Cable tray connecting plate specifications

Cable tray connection plates (splice plates) are typically fabricated from steel or aluminum, with thicknesses ranging from 3/16" to 1/4", and feature pre-drilled bolt holes to join tray sections securely while meeting NEMA and ASTM standards.Material and StandardsConnection plates are generally made from hot-dip galvanized steel, stainless steel, or aluminum, depending on environmental conditions and load requirements. They must comply with standards such as ASTM A123, ASTM A653, ASTM A1008, and NEMA VE 1 for metallic cable tray systems . Plates are designed to withstand the full cable load with a safety factor of 1.5, and concentrated loads of up to 200 lb during testing .DimensionsThickness: Commonly 3/16" to 1/4" (4.8–6.4 mm) for standard ladder or solid-bottom trays .Length and Width: Typically 6–12 inches long and 2–4 inches wide, sufficient to span the side rails of the cable tray.Bolt Hole Pattern: Pre-drilled holes are spaced to match the tray side rails, usually 1/2" to 5/8" diameter, with 2–4 holes per side depending on tray width and load requirements .Edge Design: Edges are often rounded or deburred to prevent cable damage during installation.Installation ConsiderationsPlates are used to join straight sections, tees, or bends of cable trays.Bolts and nuts are used to secure the splice plate to the tray side rails, ensuring alignment and structural integrity.For wide trays (over 24 inches), additional or reinforced plates may be required to maintain load capacity .Splice plates must allow for thermal expansion and contraction, especially in outdoor or long-span installations .Load and SafetyEach splice plate must support the full rated load of the tray section, including environmental loads such as wind or snow.The design should ensure no protrusions below the tray bottom plane to avoid cable interference .Compliance with NFPA 70 (NEC) and manufacturer-specific guidelines is essential for safety and warranty purposes . In summary, cable tray connection plates are standardized components designed to securely join tray sections, maintain structural integrity, and comply with industry standards. Proper selection of material, thickness, bolt pattern, and installation method ensures safe and reliable cable management in industrial and commercial applications.